Searching ALOHA 12.0
Setting Up ALOHA
To set up your ALOHA configuration, you use the Setup tab in the Web user interface, which reports the following information:
System
License
Remote node status in a cluster
It allows the following actions:
Manage the local and remote configuration
Update the firmware
Change local settings
Change the date and time
Change admin or monitor user credential
Handle licenses
Managing the local configuration
The ALOHA is in charge of two versions of its configuration:
The running configuration stored in memory
The startup configuration read at time of startup
Save the configuration to the flash
By design, configuration changes are applied to the running configuration but are not automatically written to the flash.
Browse the Setup tab.
Locate the Local configuration area.
Click on the "Save" button.
Note
We recommend that you perform this operation after the running configuration is modified and you are satisfied with them.
Managing the remote configuration
This feature is only available when the ALOHA is part of a cluster.
Obtaining the remote configuration status
This only reports the save status on the peer. This does not mean that the peer has the same configuration as the local node.
There are three available statuses:
means the peer's running and startup configurations are the same | |
means changes are pending in the running configuration, and a save may be required to write them to the startup configuration | |
local peer was not able to check status on the remote node, either because of configuration issue or network problem. Requires investigation. |
Save the configuration on a remote node
Browse the Setup tab.
Locate the Remote configuration area.
Click on the "Save" button.